Portatree Eliminator Super 2000 Competition-Firmware Ver. 4. Manuel d'utilisateur télécharger pdf (Page 3)

The Test light screen is for testing your Christmas tree and your stop, win, and tower

ready lights. You can turn them on and then check voltages to see if they are working. The

Eliminator based system uses a sinking signal (signal is ground - common is + voltage). The

sensor test is a very useful tool in checking sensor problems. You can click on "Sensor Test"

to what sensors change state ( dots go from white to black ), the "Glitch Test" where if a glitch

is detected the dot turns Red, or tie them to the tree so that you can watch them change by

watching the tree lights go off and on.

The Prestage are 60 foot sensors, Stage are 330 foot sensors, Top ambers are the Mid

MPH's, 660 foot are the 2nd Ambers, the 1000 foots are the 3rd Ambers, the 1/4 mile MPH's

are the Green lights, and the 1320 foots are the Red lights.

There is a busy page where you can check the connection between the Eliminator

Competition and the P.C. by clicking on the various buttons that make the tree cycle in

different ways. This requires quick communication between the Eliminator Competition and

P.C. and is a great test.

RACE SETUP SCREEN

Click on “Race” and then click on “Race Screen” to start into the Race Program. The

race setup screen will appear.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Portatree Eliminator Super 2000 Competition-Firmware Ver. 4. Manuel d'utilisateur Page 3